ASTM F 588

Active Standard:  F588-04 Standard Test Method for Measuring the Forced Entry Resistance of Window Assemblies, Excluding Glazing Impact

Developed by Subcommittee:  E06.51

See Related Work by this Subcommittee

Adoptions:  Building Codes; ANSI Approved

Book of Standards Volume:  04.12

Scope

1. These test methods determine the ability of the window assemblies of various types to restrain, delay, or frustrate forced entry.
   
   
2. For purposes of these test methods, window assemblies are defined as described in and as shown in.  Window assemblies with a combination of operable sash and fixed panes (lites) shall be classified and tested seperately for each type.
   
   
        Type A - A window assembly which incorporates one or more 
        sash that open by sliding, either vertically or horizontally,
        within the plane of the wall.
   
   
        Type B - A window assembly which incorporates one or more 
        sash that are hinged at or near two corners of the sash and 
        that open toward the exterior (outswinging) or toward the 
        interior (inswinging).
   
   
        Type C - A window assembly which incorporates one or more
        sash that are pivoted so that part of the sash opens toward
        the interior and part of it opens toward the exterior.
   
   
        Type D - A window assembly which incorporates one or more 
        fixed panes (lites) or stationary sash that are designed not to
        open.
      
   
              (Note:  See for graphic description of window assembly
                         types)
   
   
3. The values stated in SI units are to be regarded as the standard.  The values given in parenthesis are for information only.
   
   
4. This standard does not purport to address all of the safety problems, if any, associated with it's use.  It is the responsibility fo the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.